Autek Logo Wide
Display and Electronics Batch Controllers

Batch Controller - Model 424

The 424 Batch Controller is suited to flow applications where precise measurement and control of batch quantities is required. Batch total, flow rate, accumulated total and pre-set value can all be displayed in engineering units on the large LCD display. The 424 Batch Controller will interface to most flowmeters with versions available for pulse outputs.

Batch Features
Automatic Overrun Compensation
Based on previous batches. the 424 will automatically compensate for any overrun which may be caused by slow closing valves.

Batch Limit
A maximum batch quantity can be programmed during set-up, so that the operator cannot enter a batch size that exceeds this limit.

Signal Time-out
If the flow signal cuts out midway through a batch, the output relays are de-energised, and an alarm triggered via an open collector output.

Remote Start/Stop
Remote push-button switches can be connected to the rear terminal strip, to start and stop batches.

Auto Restart
The 424 Batch Controller can be programmed to automatically restart the batch after a pre-set time delay.

Count Up/Down
The instrument can be programmed to count up from zero, or to count down from the batch quantity.

End of Batch
An end of batch signal is provided via an open collector transistor output.

Additional information

Autek contact

Jann Alnes Øverland

Senior Sales Engineer

+47 47462556


No information found...


Datasheets Datasheet.pdf (497 KB)